KTM 690 Duke 2018 User Manual

COOLING SYSTEM 16
181
K00444-10
–
Remove bleeder screw
2
.
– Tilt the vehicle slightly to the right.
– Pour in coolant until it emerges without bubbles at the vent
hole, and then mount and tighten bleeder screw
2
immedi-
ately.
Coolant 1.20 l
(1.27 qt.)
Coolant ( p. 230)
– Completely fill the radiator with coolant. Mount radiator
cap
1
.
– Rest the vehicle on the side stand.
– Check the coolant level in the compensating tank. ( p. 176)
Danger
Danger of poisoning Exhaust gases are toxic and inhal-
ing them may result in unconsciousness and death.
– Always make sure there is sufficient ventilation
when running the engine.
– Use an effective exhaust extraction system when
starting or running the engine in an enclosed
space.
– Start the engine and run it until the 5th bar of the temperature
indicator lights up.
– Stop the engine and allow it to cool down.

KTM 690 Duke 2018 Specifications

General

Engine Type	Single-cylinder, 4-stroke
Displacement	690 cc
Torque	74 Nm @ 6, 500 rpm
Compression Ratio	12.7:1
Transmission	6-speed
Fuel System	Electronic fuel injection
Cooling System	Liquid cooled
Front Suspension	WP USD Ø 43 mm
Rear Suspension	WP Monoshock
Seat Height	835 mm
Dry Weight	148.5 kg
Fuel Capacity	14 liters
Bore x Stroke	105 mm x 80 mm
Starter	Electric starter
Front Wheel	3.50 x 17"
Rear Wheel	5.00 x 17"
Front Tire	120/70 ZR 17
Rear Tire	160/60 ZR 17
Power	73 hp (54 kW) @ 8, 000 rpm
Front Brake	Brembo four-piston radial caliper, 320 mm disc
Rear Brake	Brembo single-piston floating calliper, brake disc Ø 240 mm
ABS	Bosch 9M+ Two Channel ABS
Frame	Chromium-Molybdenum steel trellis frame, powder-coated