EasyManua.ls Logo

KTM Super Adventure 2016 - Installing the battery

KTM Super Adventure 2016
25 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3 WORK 13
M00610-10
Disconnect negative cable
from the battery.
Disconnect positive cable
from the battery.
Take the battery and battery case
out of the battery compartment.
3.14 Installing the battery
Warning
Risk of injuryBattery acid and battery gases cause serious chemical burns.
Keep batteries out of the reach of children.
Wear suitable protective clothing and goggles.
Avoid contact with battery acid and battery gases.
Keep sparks and open flames away from the battery. Only charge in well-ventilated rooms.
In the event of skin contact, rinse with large amounts of water. If battery acid gets in the eyes, rinse with water for at least
15 minutes and contact a physician.
Caution
Danger of accidentsIf the vehicle is operated with a discharged battery or without a battery, electronic components and safety
equipment may be damaged.
Never operate the vehicle with a discharged battery or without a battery.
M00610-11
Main work
Position the battery in battery case
.
Guideline
The even side of the battery case must be opposite the poles.
Position the battery and battery case in the battery compartment.
Position the positive cable
and mount and tighten the screw.
Guideline
Screw, battery terminal M6 4.5 Nm
(3.32 lbf ft)
Position the negative cable
and mount and tighten the screw.
Guideline
Screw, battery terminal M6 4.5 Nm
(3.32 lbf ft)
S00736-10
Close the cover
and push down slightly.
The cover engages with an audible click.
Finishing work
Mount the front rider's seat. ( p. 7)
Mount the passenger seat. ( p. 6)
Set the time and date.

Related product manuals