18 CLEANING, CARE
88
18.1 Cleaning the motorcycle
Note
Material damage Components become damaged or destroyed if a pressure cleaner is used incorrectly.
The high pressure forces water into the electrical components, connectors, throttle cables, and bearings, etc.
Pressure which is too high causes malfunctions and destroys components.
– Do not direct the water jet directly on to electrical components, connectors, throttle cables or bearings.
– Maintain a minimum distance between the nozzle of the pressure cleaner and the component.
Minimum clearance 60 cm (23.6 in)
Note
Environmental hazard Hazardous substances cause environmental damage.
– Dispose of oils, grease, cleaning agents, brake fluid etc. properly and in compliance with the applica-
ble regulations.
Info
Clean the motorcycle regularly to maintain its value and appearance over a long period.
Avoid direct sunshine when cleaning the motorcycle.
401061-01
– Remove the coarse dirt particles with a gentle water jet.
– Spray the heavily soiled parts with a normal commercial motor-
cycle cleaner and clean using a brush.
Motorcycle cleaner ( p. 99)
Info
Use warm water containing normal motorcycle cleaner
and a soft sponge.
Never apply motorcycle cleaner to the dry motorcycle.
Always rinse the motorcycle with water before use.
– After rinsing the motorcycle with a gentle spray of water, allow
it to dry thoroughly.
Warning
Danger of accidents Moisture and dirt impair the
brake system.
– Explain to your child that he or she must brake
carefully several times to dry out and remove dirt
from the brake linings and the brake discs.
– After cleaning, your child should ride a short distance until the
brake system has dried through careful braking.
Info
The heat causes the water to evaporate even in inacces-
sible parts of the vehicle.
– After the motorcycle has cooled down, lubricate all moving
parts and pivot points.
– Clean the chain. ( p. 56)
To Next Page
Loading...
Need help?
General
