LUBRICANTS, FUEL, AND COOLANT
IMPORTANT :
•
To prevent serious damage to hydraulic systems, use only KUBOTA genuine fluid or its equivalent.
No. Locations
Capacities
Grade
BX1880 BX2380 BX2680
1 Fuel
25 L
(6.6 U.S.gals.)
No. 2-D diesel fuel
No. 1-D diesel fuel if temperature is below
-10 ℃
(14 ℉)
2 Coolant with recovery tank
2.9 L
(3.06 U.S.qts.)
3.1 L
(3.3 U.S.qts.)
3.3 L
(3.5 U.S.qts.)
Fresh clean soft water with anti-freeze
3 Engine crankcase
3.0 L
*1
(3.17 U.S.qts.)
3.3 L
*1
(3.49 U.S.qts.)
4.0 L
*1
(4.23 U.S.qts.)
• Engine oil
API Service Classification CF or higher
Above 25 ℃ (77 ℉) SAE30, SAE10W-30 or 15W-40
-10 ℃ to 25 ℃
(14 ℉ to 77 ℉)
SAE20, SAE10W-30, or 15W-40
Below -10 ℃ (14 ℉) SAE10W-30
4 Transmission case
11.3 L
(2.99 U.S.gals.)
• KUBOTA SUPER UDT-2 fluid
*2
5 Front axle case
3.6 L
(3.8 U.S.qts.)
• KUBOTA SUPER UDT-2 fluid
*2
or SAE 80-SAE90 gear
oil
6
Greasing No. of greasing points Capacity Type of grease
Battery terminal 2 moderate amount
Multipurpose
EP2 Grease (NLGI Grade No.2)
Speed control pedal 1 until grease overflow
Rear link 4 moderate amount
Bonnet lock 1 moderate amount
Bonnet guide 1 moderate amount
*1 Oil amount when the oil level is at the upper level of the oil level gauge.
*2
The product name of KUBOTA genuine UDT fluid may be different from that in the operator's manual depending on countries or territories.
Consult your local KUBOTA Dealer for further detail.
Fuel
• Cetane
number
of 45 is minimum. Cetane number greater than 50 is preferred, especially for the following
temperatures or the following elevations.
Temperatures Below -20 ℃ (-4 ℉)
Elevations Above 1500 m (5000 ft)
• Diesel fuels specified to EN 590 or ASTM D975 are recommended.
• No.2-D is a distillate fuel of lower volatility for engines in industrial and heavy mobile service (SAE J313 JUN87).
Engine oil
•
Oil used in the engine should have an American Petroleum Institute (API) service classification and proper SAE
engine oil according to the ambient temperatures as shown in the preceding table.
• Refer to the following table for the suitable API classification engine oil according to the engine type with internal
EGR, external EGR, or non-EGR, and the fuel.
Fuel used
Engine oil classification (API classification)
Oil class of engines except external EGR Oil class of engines with external EGR
Ultra low sulfur fuel [<0.0015%
(15 ppm)]
CF, CF-4, CG-4, CH-4, or CI-4
CF, or CI-4
You cannot use the class CF-4, CG-4, and CH-4 en-
gine oils on ERG-type-engines.
EGR
Exhaust gas re-circulation
• The CJ-4 engine oil is intended for DPF (diesel-particulate-filter) type engines, and cannot be used on this tractor.
LUBRICANTS, FUEL, AND COOLANT MAINTENANCE
To Next Page
Loading...
Need help?
General
