3. Shift the range-gear-shift-lever to the neutral
“N” position.
4. Check whether the speed-control-pedal is in the
neutral position.
5. Shift the PTO-clutch-lever to the off position.
[Test 1] Switches for the operator's seat and the
speed control pedal
1. Start the engine.
2. Depress the speed-control-pedal.
3. Stand up.
Do not get off the machine.
The engine must shut off after approximately one
second. If it does not stop, consult your local KUBOTA
Dealer.
[Test 2] Switches for the operator's seat and the
PTO clutch lever
1. Start the engine.
2. Engage the PTO-clutch-lever.
3. Stand up.
Do not get off the machine.
The engine must shut off after approximately one
second. If it does not stop, consult your local KUBOTA
Dealer.
(1) Range gear shift lever (Hi-
Lo)
(2) PTO clutch lever
(3) Speed control pedal
4. Checking the wheel bolt torque
WARNING
To avoid serious injury or death:
• Never operate the tractor with a loose rim,
wheel, or axle.
• Any time bolts are loosened, retighten to the
specified torque.
• Check all bolts frequently and keep them tight.
1. Check the wheel bolts regularly especially when
new.
2. If they are loose, tighten them as follows.
Front
Rear
(1) 149.2 N
⋅
m to 179.0 N
⋅
m
(15.2 kgf
⋅
m to 18.3 kgf
⋅
m)
(110 lbf
⋅
ft to 132 lbf
⋅
ft)
(2) 108.5 N
⋅
m to 130.2 N
⋅
m
(11.1 kgf
⋅
m to 13.3 kgf
⋅
m)
(80 lbf
⋅
ft to 96 lbf
⋅
ft)
5. Cleaning the lock lever shaft
1. Before you use the lock lever, clean the lever-
movable-area (1).
(1) Lever movable area
SERVICE EVERY 50 HOURS PERIODIC SERVICE
To Next Page
Loading...
Need help?
General
