4. Properly dispose of the used engine oil.
BX1880 and BX2380
BX2680
BX1880, BX2380, and BX2680
(1) Oil inlet
(2) Dipstick
(3) Drain plug
(A) Oil level is acceptable within
this range
3. Replacing the transmission oil
filter
WARNING
To avoid serious injury or death:
• Be sure to stop the engine before changing the
transmission oil filter cartridge.
• Oil can be hot and can burn. Allow the engine to
cool down sufficiently.
IMPORTANT :
• To prevent serious damage to the hydraulic
system, use only a KUBOTA genuine filter.
1. Remove the transmission oil filter.
2. Put a film of clean transmission oil on rubber seal of
new transmission oil filter.
3. Tighten the transmission oil filter quickly until it
contacts the mounting surface.
4. Tighten the transmission oil filter by hand an
additional 1/2 turn only.
5. After the new transmission oil filter has been
replaced, the transmission fluid level will decrease a
little. Make sure that the transmission fluid does not
leak through the seal, and check the fluid level.
Check the dipstick and refill with oil to prescribed
level.
6. Properly dispose of used oil.
(1) Filter
4. Checking the toe-in
WARNING
To avoid serious injury or death:
• Park the tractor on a firm, flat, and level place.
• Lower the implement to the ground, and apply
the parking brake.
• Stop the engine and remove the key.
1. Turn the steering wheel so that the front wheels are
in the straight ahead position.
2. Measure the distance between the tire beads at
front of the tires, and at the hub heights.
3. Measure the distance between the tire beads at
rear of the tires, and at the hub heights.
SERVICE EVERY 200 HOURS PERIODIC SERVICE
To Next Page
Loading...
Need help?
General
