Kubota L3200 Assembly Instructions

ASSEMBLY INSTRUCTIONS28
BCrate Base
To avoid personal injury:
A After attaching the three point linkage to the
tractor body, lift both lower links with two belt
sling (over 2 tons capacity).
A Place the safety stands (over 2 tons capacity)
under the rear axle cases after lifting the
tractor.
A Make sure to place the safety stands under the
rear axle cases before starting next jobs.
C Tools required
Belt sling, safety stands.
1. Lift the rear side of the tractor with the belt slings (2).
2. The pad is put between ROPS and chain not to
damage ROPS as shown in the photo below.
3. Set the jig casters (3) to the crate base (4).
4. Pull out the crate base (4) from the tractor.
(1) Lower links
(2) Belt slings
(3) Jig caster
(4) Crate base
(4) Crate base

Kubota L3200 Specifications

General

Engine Type	Diesel
Drive	4WD
Hydraulic System	Open center
3-Point Hitch	Category I
Engine Power	31.9 HP
Number of Speeds	8 forward and 4 reverse
PTO Horsepower	25.5 HP
Engine Model	D1703-M
Width	55.1 inches
Height	91.7 inches