KYMCO GRAND DINK 250 User Manual

3. INSPECTION/ADJUSTMENT
3-9
GRAND DINK 250
HEADLIGHT AIM
Turn the ignition switch ON.
Turn on the headlight switch.
Adjust the headlight aim by turning the
headlight aim adjusting bolt.
CLUTCH SHOE WEAR
Start the engine and check the clutch
operation by increasing the engine speed
gradually.
If the motorcycle tends to creep or the engine
stalls, check the clutch shoes for wear and
replace if necessary.
COOLING SYSTEM
COOLANT LEVEL INSPECTION
Place the motorcycle on its main stand on
level ground.
Check the coolant level of the reserve tank
and the level should be between the upper
and lower level lines.
If necessary, fill the reserve tank with
recommended coolant to the “F” level line.
Recommended Coolant: SIGMA Coolant
(Standard Concentration 30%)
COOLANT REPLACEMENT
Remove the front cover.
Remove the radiator cap.
Remove the drain bolt to drain the coolant
and tilt the motorcycle to the right and the
coolant will drain more easily.
Drain the coolant in the reserve tank.
Reinstall the drain bolt.
Fill the radiator with the specified coolant.
Headlight Aim Adjusting Bol
t
Upper Line
Lower Line
Radiator Cap
• The coolant level does not change no
matter the engine is warm or cold. Fill
to the “F” (upper) line.

• The coolant freezing point should be 5
 lower than the temperature of the
riding area.

• Perform this operation when the engine
is cold.

Reserve Tank

KYMCO GRAND DINK 250 Specifications

General

Brand	KYMCO
Model	GRAND DINK 250
Category	Scooter
Language	English