KYMCO GRAND DINK 250 User Manual

13. FUEL SYSTEM/CARBURETOR/
FUEL PUMP/ FUEL TANK
13-11
GRAND DINK 250
AUTO BYSTARTER INSPECTION
/REMOVAL
AUTO BYSTARTER INSPECTION
Measure the resistance between the auto
bystarter wire terminals.
Resistance: 10Ω (10 minutes minimum after
stopping the engine)
If the reading is not within the limit, replace
the auto bystarter with a new one.
Connect a hose to the fuel enriching circuit
of the carburetor. Connect the auto
bystarter green/black wire to the positive (+)
terminal of a battery and black/white wire to
the negative (-) terminal. Wait 5 minutes
and blow the hose with mouth. If the
passage is blocked, the auto bystarter is
normal.
Disconnect the auto bystarter from the
battery. Wait 30 minutes and blow the
hose with mouth.. If air can be blown into
the hose, the auto bystarter is normal.
AUTO BYSTARTER REMOVAL
Remove the one set plate screw and set plate
and then remove the auto bystarter from the
carburetor body.
B/W
Hose
Screws Auto B
y
starte
r
Set Plate
G/B

KYMCO GRAND DINK 250 Specifications

General

Brand	KYMCO
Model	GRAND DINK 250
Category	Scooter
Language	English