4-73
Operation Panel
Netware (NetWare setting)
NetWare is a PC-based network operating system specifically for servers. NetWare is a client-server system that operates
by installing the NetWare OS on the server and dedicated client modules (NetWare clients) on the client machines (running
MS-DOS, OS/2, Windows, etc.). The basic network layer protocol used is NetWare's own IPX (Internetwork Packet
eXchange)/SPX (Sequenced Packet eXchange), but the system also supports TCP/IP.
The feature of the NetWare OS is that it is specifically for servers, unlike general-purpose operating systems such as
Windows NT and UNIX. Only the minimum required for server operation can be performed from the NetWare OS console
on the server. Server and file management is basically carried out using management tools from the clients. Also, all drivers
and protocol stacks are in the form of modules called NetWare Loadable Modules (NLMs), and the ability of NLMs to load
and unload flexibly and dynamically is a major advantage of this system.
1
In the Basic menu, press or to select Netware.
2
Press [OK]. The Netware screen appears.
3
Press or to select whether NetWare is enabled.
4
Press [OK]. The NetWare setting is set and the Basic menu
reappears.
AppleTalk (AppleTalk setting)
AppleTalk is a communications protocol used primarily on Macintosh computers and also refers to the Mac OS network
functions.
AppleTalk assigns 24-bit network addresses (a 16-bit network section and an 8-bit node address) that are used to identify
devices (computers, printers, etc.) on the network.
When the power is turned on, a broadcast signal is sent out onto the network and the addresses and machine names are
automatically assigned. The default setting is On.
1
In the Basic menu, press or to select AppleTalk.
2
Press [OK]. The AppleTalk screen appears.
3
Press or to select whether AppleTalk is enabled.
4
Press [OK]. The AppleTalk setting is set and the Basic menu
reappears.
IPSec (IPSec setting)
IPSec (IP Security Protocol) is a security protocol adopted as the standard by the IETF for authentication and encryption in
the third network layer (IP layer).
It can be used with both IPv4 and IPv6.
1
In the Basic menu, press or to select IPSec.
To Next Page
Loading...
Need help?
General