Kyocera ECOSYS FS-2100D User Manual

Operation Panel
4-74
2 Press [OK]. The IPSec screen appears.
3 Press  or  to select whether IPSec is enabled.
4 Press [OK]. The IPSec setting is set and the Basic menu reappears.
LAN Interface (LAN Interface setting)
Specify the settings for the LAN interface to be used. The default setting is Auto.
1 In the Basic menu, press  or  to select LAN Interface.
2 Press [OK]. The LAN Interface screen appears.
The available LAN Interface are as follows:
Auto
10BASE-Half
10BASE-Full
100BASE-Half
100BASE-Full
1000BASE-T
3 Press  or  to select the desired LAN Interface.
4 Press [OK]. The LAN Interface is set and the Basic menu
reappears.
MACAddressFilter (MAC address filtering setting)
This sets whether or not to enable MAC address filtering.
1 In the Basic menu, press  or  to select MACAddressFilter.
2 Press [OK]. The MACAddressFilter screen appears.
3 Press  or  to select whether MAC address filtering is enabled.
4 Press [OK]. The MAC address filtering setting is set and the Basic
menu reappears.
Restart Network (Restarting the optional Network Interface Kit)
After all network related settings have been done, restart the network card of the device. This is mandatory to make the
settings effective.
1 In the Basic menu, press  or  to select Restart Network.
IPSec:
Off
01
On
02
*
Note LAN Interface is only displayed when the optional Network Interface Kit (IB-50) is installed.
LAN Interface:
Auto
01
10BASE-Half
02
*
10BASE-Full
03
Note The detailed settings for MAC address filtering are selected using the optional Network Interface Kit utility
software.
MACAddressFilter:
Off
01
On
02
*

Kyocera ECOSYS FS-2100D Specifications

General

Brand	Kyocera
Model	ECOSYS FS-2100D
Category	Printer
Language	English