3-24
Basic Operation
If the connection is successful, Connected. is displayed
on the screen. Press [OK] (the Right Select key).
Completed. is displayed and the screen returns to the
basic screen.
If the connection failed, Cannot connect. is displayed.
Press [OK] (the Right Select key). The screen shown in
step 3 reappears. Check and re-enter the destination.
13
If there are additional destinations, press the Add
Destination key. Repeat steps 2 to 12 to enter additional
destinations. Up to 100 destinations can be specified.
14
Press the Confirm Destination key to confirm the
registered destinations.
Press the U or V key to select a destination and press
the OK key. Then, you can edit or delete the destination.
Press [Exit] (the Right Select key) to return to the basic
screen.
15
Press the Start key. Transmission starts.
NOTE: If the screen for confirming the destination before
transmission (page 8-88) is set to [On], the Confirm
Destination screen appears when the Start key is pressed.
For more information, refer to Confirm Destination Screen
on page 3-25.
To Next Page
Loading...
Need help?
General