Settings Pages
This displays the list of IP addresses and subnet masks (IPv4) or prefix
length (IPv6) that have access permission as set under IP Filters (IPv4) and
IP Filters (IPv6) on the Advanced page. If no IP addresses have been
designated, then access permission will be granted to all addresses. For
more information, refer to Advanced > Protocols > TCP/IP > IP Filters on
page 6-34.
Network > SNMP
This allows you to verify the settings made under SNMPv1/ v2 and SNMPv3
on the Advanced page. For more information on SNMPv1/v2, refer to
Advanced > Management > SNMP > SNMPv1/v2c on page 6-42. For more
information on SNMPv3, refer to Advanced > Management > SNMP >
SNMPv3 on page 6-43.
Network > POP3/SMTP
This allows you to verify the E-mail-related settings made on POP3 and
SMTP pages of the Advanced page. For more information on POP3, refer to
Advanced > E-mail > POP3 > General on page 6-41. For more information
on SMTP, refer to Advanced > E-mail > SMTP > General on page 6-38.
Network > Logical Printers
This allows you to verify the settings made on the Logical Printers page of
the Advanced page. For more information, refer to Advanced > Protocols >
TCP/IP > Logical Printers on page 6-35.
Network > NetWare
This allows you to verify the settings made on the NetWare page of the
Advanced page. For more information, refer to Advanced > Protocols >
NetWare on page 6-36.
Security
This allows you to verify the current settings for secure protocols,
IEEE802.1x, and IPSec. To change the settings: For secure protocols, refer
to Advanced > Security > Secure Protocols on page 6-49. For IEEE802.1x,
refer to Advanced > Security > IEEE802.1x on page 6-50. For IPSec, refer to
Advanced > Security > IPSec > Rule1 (to Rule3) on page 6-51.
Device/Printer
This allows you to verify the settings made on the Basic and the Printer
pages. For more information, refer to Basic Page on page 6-4 and Printer
Page on page 6-13.
Device/Printer > APL.Filter
This allows you to verify the settings made on the Basic and the Printer
pages. For more information, refer to Printer Page on page 6-13.
Device/Printer > APL.Filter Parameters
This allows you to verify the settings made on the Basic and the Printer
pages. For more information, refer to Printer Page on page 6-13.
Scanner
This allows you to verify the settings made on the Scanner page. For more
information, refer to Scanner Page on page 6-15.
FAX / i-FAX > General, FAX, i-FAX
This allows you to verify the settings made on the FAX / i-FAX page. For
more information, refer to FAX / i-FAX Page on page 6-20.
Counters > Printed Pages
COMMAND CENTER RX 6-3
To Next Page
Loading...
Need help?
General