Settings Pages
sysLocation
The MIB-II sysLocation object. Usually this is the location information of the
printing system which is described under Device Defaults. To change
location, go to Location in Basic > Defaults > Device Defaults.
HP Web Jetadmin Compatibility
Turns HP Web Jetadmin Compatibility On or Off. After you have changed
the setting, you must restart the printing system.
Authentication Traps
Specifies whether to use authentication traps. If enabled (On), an SNMP trap
is generated when an attempt to read or write is made using an incorrect
community name. The trap is sent to the configured trap address. After you
have changed the setting, you must restart the printing system.
Trap Community
The SNMP trap community name to be used when the printing system
generates a trap.
Trap IP Address (IPv4)
Enter the IPv4 address that receives traps. Select On to enable trap
receiving.
Trap IP Address (IPv6)
Enter the IPv6 address that receives traps. Select On to enable trap
receiving.
Trap IPX Address
Enter the IPX address that receives traps. Select On to enable trap
receiving.
Selected Errors
Select the events which will cause a trap to be generated from Add Paper,
Low Toner, Add Toner, Cover Open, Paper Jam, and All Other Errors.
Advanced > Management > SNMP > SNMPv3
The section below provides a summary of the items displayed on the SNMPv3
page. After you have changed the setting, you must restart the printing system.
SNMPv3
Sets whether to use the SNMPv3 protocol. Set On to use it.
Authentication
Sets whether to authenticate the user in SNMP communication.
Hash
Selects the hash algorithm. This item is displayed when the Authentication
is On.
Privacy
Sets whether to encrypt the communicated data in SNMP communication.
This becomes available when Authentication is enabled.
Encryption
Selects the encryption algorithm. This item is displayed when Privacy is On.
User Name
Enter the name of the read-only user.
Password
COMMAND CENTER RX 6-43
To Next Page
Loading...
Need help?
General