Settings Pages
Each logical printer can be used with either of the following print protocols: FTP,
LPR, IPP, IPPS, SMB (NetBEUI), or RAW. If no port is specified when printing,
the default port used will be Logical Printer 1 (LP1), port 9100.
TCP/IP Port Number
Specifies the port number for the logical printer as well as the TCP raw port
number (9100, etc.). Conversion is applied to data that is input to the
specified raw port in accordance with the selected logical printer. This port is
invalid if it is given a port number that is the same as that of an already
specified port (For example, FTP or LPD).
Bi-directional Printing
Bi-directional Printing can be set to On or Off when printing to the TCP/IP
RAW port. When Bi-directional Printing = Off, all send data is discarded. In
order to have the data that is received from the printer returned to the client
when printing with PostScript, PJL and other such commands, it is
necessary to set Bi-directional Printing = On.
Start of Job String
Specifies the character string sent to the printer before output, directly to the
output port (lp port). This character string is used when it is necessary to
transmit a control code before the print data is sent.
End of Job String
Specifies the character string sent to the printer after output, directly to the
output port (lp port). This character string is used when it is necessary to
transmit a control code after the print data is sent.
Advanced > Protocols > NetWare
This printing system supports both NDS and bindery printing in either print
server mode or remote printer mode.
NetWare setup requires installation of the following client software and login
with Administrator Privileges. If you are unsure, please contact your network
administrator.
With Novell Client, creation of the NetWare print objects with the AdminManager
NetWare Setup Wizard requires the NetWare Client from Novell. For NetWare
printing, you may use the NetWare Client from either Novell or Microsoft.
For Admin Privileges, network operations (creating queues etc.) require 'admin'
or 'supervisor' privileges (or equivalent). Certain portions of AdminManager may
be inoperable if you attempt those operations without sufficient privileges.
NetWare Protocol
Enables or disables the Network Protocol.
Bindery Mode
Enables or disables Bindery Mode.
Frame Type
Sets the Frame type. You can choose from Auto, 802.3, Ethernet-II, SNAP or
802.2.
File Server (Primary)
Enter the name of the primary File Server.
NDS Tree
Enter the name of the NDS Tree.
NDS Context
6-36 User Guide
To Next Page
Loading...
Need help?
General