Settings Pages
RAM Disk Size
Specifies the size of the RAM disk. For allowable sizes, refer to the print
system operation guide. After you have changed the setting, you must
restart the printing system.
File Name
You can change the file name for the scan data or the job name for the jobs
on the Job page.
Additional Information
You can add a Job Number or the Data and Time to the File Name
designated above. The additional information varies depending on the
model.
Skip Error Job
Turns Skip Error Job on and off, which automatically terminates processing a
job on an error and skips to process the next job. The time period (interval)
for the system to wait until the job is skipped can be set by Set Interval
below.
Set Interval
Selects the time period until Skip Error Job is activated from 5 to 90 seconds.
MP Tray Empty
With the MP tray set as the default paper source, this enables (On) or
disables (Off) the paper empty message when the MP tray becomes empty.
Unusable Time Setting (when FAX is installed)
This restricts use of the machine by time of day. When turned On, the
machine becomes inoperative during the time of day specified by Unusable
Time. Except, the received faxes are stored in the machine and printed after
the inoperative time period has been expired.
Unusable Time
This determines the time period during which the machine is restricted for
use. This is enabled when Unusable Time Setting is On.
Unlock Code
Entering this code, comprised of four digits from 0 to 9, temporarily allows
the machine to be usable during the time period of restriction.
Dest(ination) Check Before Send
This enables the front panel message which prompts you to confirm the
destination to forward the scan data. The message is displayed when the
machine's Start key is pressed to start scanning.
Entry Check for New Dest(ination)
When enabled, this determines whether the re-entry of a password for
confirmation is required when adding a new destination.
Default Screen (Send/FAX)
You can select either Destinations or Address Book to be displayed by
default on the print system's display while using send or FAX mode.
USB Keyboard Type
This tells the system the type of the keyboard being connected to the USB
port. In order for the keyboard to properly operate, specify the correct type.
Low Toner Alert Level
6-8 User Guide
To Next Page
Loading...
Need help?
General