2NM/2NX/2NY/2NZ/2P0/2P6
1-4-111
(2) Table of general classification
Error code Description
U00000 No response or busy after the set number of redials.
U00100 Transmission was interrupted by a press of the stop/clear key.
U00200 Reception was interrupted by a press of the stop/clear key.
U00300 Recording paper on the destination unit has run out during transmission.
U004XX A connection was made but interrupted during handshake with the receiver unit (See
page 1-4-114 ).
U00500 Multiple communication was interrupted and call was not made on destination units after
interruption.
U006XX Communication was interrupted because of a machine problem (See page 1-4-115 ).
U00700 Communication was interrupted because of a problem in the destination unit.
U008XX A page transmission error occurred in G3 mode (See page 1-4-115 ).
U009XX A page reception error occurred in G3 mode (See page 1-4-115 ).
U010XX Transmission in G3 mode was interrupted by a signal error (See page 1-4-116 ).
U011XX Reception in G3 mode was interrupted by a signal error (See page 1-4-118 ).
U01400 An invalid one-touch key was specified during communication.
U01500 A communication error occurred when calling in V.8 mode.
U01600 A communication error occurred when called in V.8 mode.
U017XX A communication error occurred before starting T.30 protocol during transmission in V.34
mode (See page 1-4-119 ).
U018XX A communication error occurred before starting T.30 protocol during reception in V.34
mode (See page 1-4-120 ).
U02000 Relay broadcast was refused by a relay station because of a mismatch in permit ID num-
ber and permit telephone number when a relay command was issued.
U02100 A relay command failed because the destination unit (relay station) had no relay broad-
cast capability.
U02200 A relay command from a command station failed because a telephone number that was
not registered in the relay station was specified. Or, relay broadcast was requested to a
relay station but failed because a telephone number that was not registered in the relay
station was specified. Or, Subaddress-based relay broadcast transmission failed
because the data registered in the Subaddress relay box was deleted.
U023XX Receiving station information was not normally received in reception of a relay command
(See page 1-4-120 ).
U02400 An interoffice subaddress-based relay transmission was interrupted because of a mis-
match in the specified relay box number.
U03000 No document was present in the destination unit when polling reception started.
U03100 In reverse polling, although no original was set in the destination unit, transmission was
complete.
U03200 In confidential polling reception, data was not accumulated in the specified box in the
destination unit. Or, in interoffice subaddress-based bulletin board reception, data was
not stored in the box specified by the destination unit.
To Next Page
Loading...
Need help?
General
