10-18
Troubleshooting > Troubleshooting
Cannot print with USB
memory.
USB memory not
recognized.
Is the USB host blocked? Select [Unblock] in the USB host
settings.
page 8-46
― Check that the USB memory is
securely plugged into the machine.
―
While "Auto-IP" is already
set to [On], the IP
address is not assigned
automatically.
Is a value other than "0.0.0.0"
entered for the link local address of
TCP/IP(v4)?
Enter "0.0.0.0" for the IP address of
TCP/IP(v4).
page 2-25
Cannot connect to this
machine by using Wi-Fi
Direct.
Are three handheld devices
connected simultaneously?
Release the connection of handheld
devices being connected manually
or set a connection after setting the
connection time and releasing the
connection by automatic
disconnection.
page 8-30
Cannot send via the
e-mail.
Is the E-mail send size limit set in
the SMTP server registered on the
machine?
Check the limit value is entered to
"E-mail Size Limit" of [E-mail]
setting in Command Center RX and
change the value as necessary.
page 2-55
The machine is emitting
steam in the area around
the paper ejection slot.
Check the room temperature to see
if it is low, or if damp paper was
used.
Depending on the printing
environment and the paper's
condition, the heat generated during
printing will cause the moisture in
the paper to evaporate, and the
steam emitted may look like smoke.
This is not a problem, and you can
continue printing. If the steam
concerns you, raise the room
temperature, or replace the paper
with a newer, dryer paper.
―
Symptom Checkpoints Corrective Actions
Reference
Page
To Next Page
Loading...
Need help?
General
Weight and Dimensions
