2-1
Section 2 NAMES OF PARTS
1. Main body
6
7
5
4
3
2
1
!
8
9
0
@
1 Operation panel
(Perform copy operations here.)
2 Cover on the right side of the operation panel
(Open this cover when you need to add toner.)
3 Front cover
(Open this cover if a paper misfeed occurs inside the copier.)
4 Drawer[Cassette] No.1
(This drawer[cassette] has a storage capacity of 500 sheets of
standard copy paper.)
5 Drawer[Cassette] No.2
(This drawer[cassette] has a storage capacity of 500 sheets of
standard copy paper.)
6 Drawer[Cassette] No.3
(This drawer[cassette] has a storage capacity of 1000 sheets of
standard copy paper.)
7 Drawer[Cassette] No.4
(This drawer[cassette] has a storage capacity of 1500 sheets of
standard copy paper.)
8 Multi-bypass tray
(Set copy paper on this tray when you want to copy onto small
paper sizes or onto special types of paper.)
9 Insert guides
(Align these guides to fit the width of the paper that is to be set on
the multi-bypass tray.)
0 Multi-bypass extension
(Pull out this extension when copying onto 8 1/2" x 11", 11" x 17",
B4 or A3 size paper.)
! Right cover
(Open this cover if a paper misfeed occurs inside the copier.)
@ Waste toner box
(The waste toner box should be replaced by your service
representative.)
To Next Page
Loading...
Need help?
General