Laser 5091 Code Reader User’s Guide
26
Laser 5091 Code Reader User’s Guide
27
Figure 4-41 Sample Non-CAN vehicle test screen
For CAN vehicles, test screen is illustrated below:
For non-CAN vehicles, test screen is illustrated below:
Figure 4-42 Sample Can vehicle test screen
4. Press the BACK key to exit and return.
4.8 Component Test
Component Test allows the code reader to control operation of vehicle components, tests or
systems.
NOTE
● Some manufacturers do not allow tools to control vehicle systems.
● The manufacturer sets the criteria to automatically stop test. Refer to appropriate vehicle service
manual before using this function.
To perform a component test:
1. Use the UP/DOWN key to highlight Component Test from Diagnostic Menu and press the
ENTER key. A screen with a list of available tests displays.
Figure 4-43 Sample Diagnostic Menu Screen
2. Use the UP/DOWN key to highlight a system or component, press the ENTER key to start test
and the code reader displays the message “Command Sent!”.
Figure 4-44 Sample Component test screen
3. Press the BACK key to exit and return.
4.9 Request Vehicle Information
Vehicle Information allows to request the vehicle’s VIN number, calibration ID(s) which identifies
software version in vehicle control module(s), calibration verification numbers (CVN(s)) and
in-use performance tracking on model year 2000 and newer OBD II compliant vehicles.
CVNs are calculated values required by OBD II regulations. They are reported to check if
emission-related calibrations have been changed. Multiple CVNs may be reported for a control
module. It may take several minutes to do the CVN calcu
latio
n. In-use performance tracking
tracks performance of key readiness monitors.
NOTE
Available options will vary depending on the vehicle under test.
To Next Page
Loading...
Need help?
General
