iComfort Wi-Fi
®
7-Day Programmable Communicating Thermostat
Page 15
Adjusting Room Temperature, Away Mode, Clock and Weather
Adjust temperature when programming is OFF — When the
programming is OFF, the system mode button (shown in figure 21, labeled
heat or cool) indicates a manual mode (no mention of “program”). In this
mode, touch one of the two set temp buttons to change the temperature
setting. The up/down arrows appear, allowing you to adjust the “cool to” (or
“heat to”) values to the desired temperature setting.
This setting will remain until you decide to change it again. (The inset shows
an alternate configuration of button layout in non-program mode.)
use arrows
to change
temperature
?
touch
cool-to
button
indoor temperature
indoor humidity is 41%
fan is
OFF
fan is
AUTO
cool-to
set temp
75
heat to
70
heat
or
cool
fan is
AUTO
system is cooling
alternate
cool-only button
layout
(system
mode button)
9:39 am May 23, 2012Wi-Fi
?
enter
away
cool-to
set temp
75
cool
only
fan is
AUTO
Figure 21. Adjusting Temperature with NO Program Running
Away Mode (Vacation) — The enter away mode button on the home
screen (upper right-hand corner) sets the system for manual operation and
allows you to set the thermostat for energy-saving operation while you are
gone for an extended period of time. In this mode, the system will only come
on if the indoor temperature falls below a set value in the heating mode (62º F
default), or if the indoor temperature rises above a set value in the cooling
mode (85º F default). You may adjust these settings as desired (see figure
22). To exit the away mode, touch cancel away mode.
indoor temperature
9:39 am May 23, 2012
cool-to
set temp
82
heat to
60
use arrows to
change
temperature
?
9:39 am May 23, 2012
Wi-Fi
?
cancel
away
system is currently using energy saving AWAY settings
Figure 22. Adjusting Temperature with Program Running
(Away Mode)
indoor temperature
indoor humidity is 41%
fan is
OFF
9:39 am May 23, 2012
fan is
AUTO
cool-to
set temp
75
heat to
72
program hold until next
program setting
other options include
system is cooling
use arrows to
change
temperature
?
1hr 2hr
8hr 24hr
custom
select an option or do nothing to
accept the default “Program
d”hold until next period”
Program hold until
next period
cancel
(other options menu)
9:39 am May 23, 2012
Wi-Fi
?
enter
away
Figure 23. Adjusting Temperature with Program Running
(other options)
To Next Page
Loading...
Need help?
General
