507342-01
Page 20
Dehumidification Controls (Non-Communicating Outdoor Unit): Touch
the humidifier setting button you want to adjust. If it says de-humidifier OFF,
one touch will display a selection for OFF, MEDIUM and HIGH. Select
MEDIUM or HIGH to bring on the set-to button. When you touch the set-to
button, the arrows appear, allowing you to change to the desired humidity
setting.
Three climate settings are available for non-communicating equipment:
OFF The system supplies higher indoor airflow at all compressor
capacities. This will increase efficiency by operating at a higher
sensible-to-total ratio.
MEDIUM The system controls indoor airflow to ensure balanced
efficiency and comfort.
HIGH The system lowers the indoor airflow at all compressor
capacities. This setting improves humidity removal by operating at a
lower sensible-to total-ratio.
Remember that the humidification controls are only active while the system
is in the heating mode. The dehumidification controls are only active while in
the cooling mode.
SYSTEM SETTINGS
current indoor humidity is 50%
heating
mode
COMFORT
humidifier
is ON
de-
humidifier
MEDIUM
40
%
set to
50
%
set to
ALL CHANGES MADE ON
THIS SCREEN ARE IN
STANTLY SAVED.
9:39 am May 23, 2012 ?Wi-Fi
OFF
MEDIUM
HIGH
humidifier
display
is ON
(default is ON)
humidification
settings
dehumidification
settings
Figure 33. Humidifier Controls (Non-Communicating Outdoor Unit)
Connecting to a Home Wi-Fi Router
Check the router utility program or contact service provider for help.
The Wi-Fi thermostat must be close enough to the Wi-Fi router to ensure a
good communications signal between the thermostat and the router. (Hint:
use a smart phone with Wi-Fi and Wi-Fi finder application to locate and
determine signal strength.)
NOTE - The thermostat will not be able to reliably connect to the router
if the received signal strength indicator (RSSI) shows a larger negative
number than 70 i.e. 75, etc.
Secure Connection Recommended! Verify that the router is
compatible with and set to operate in either 802.11b, 802.11g or 802.11n
wireless network modes. Check router utility program or contact
service provider for assistance.
Below are some possible conditions that will cause wireless interference
with the thermostat resulting in poor signal reception.
Portable phones and bases
Baby monitors
Wireless speakers
Bluetooth devices
Garage door openers
Neighbors' wireless devices.
To eliminate a possible source of interference, temporarily disable any
devices and see if Wi-Fi performance has improved.
ENABLING WI-FI
To enable the Wi-Fi feature to communicate with a wireless router
To Next Page
Loading...
Need help?
General
