Lennox V0STAT51P-3 User Manual

4
• This manual provides the installation
instructions for this controller. Refer to the
included wiring diagrams to connect the
controller to the indoor unit.
• The controller uses low voltage. Keep a
minimum distance of 12” (305 mm) between
low voltage control wire and high voltage
power wires.
Power wiring between controller and rst
indoor unit:
• Minimum 18 AWG stranded, shielded cable
up to 164 feet (50 m).
• Ensure there are no gaps between the con-
troller back cover and the mounting surface.
• Fill any holes in the wall behind the control-
ler to avoid false readings from inltration.
• Ground the shielded control wiring.
• Do not use a megger to test insulation.
Communication wiring between indoor
units:
• Minimum 18 AWG stranded, shielded cable.
Installation
CAUTION
!
Do not install controller in areas where
harmful gases containing sulfur or
other damaging agents may exist or the
controller may be damaged.
Clean controller using a clean, damp
cloth. Do not spray cleanser on or around
controller.
Be sure that power supply has been
turned o󰀨 before beginning installation.
Do not operate controller with wet hands.
WARNING
!
IMPORTANT
Read all of the information in this manual
before using this controller. All wiring must
conform to local and national building and
electrical codes and ordinances. This is a
12 VDC controller. Do not install on voltages
higher than 12 VDC.
IMPORTANT
Electrostatic discharge can a󰀨ect electronic
components. Take precautions to neutralize
electrostatic charge by touching your hand
and tools to metal prior to handling the con-
trol.

Lennox V0STAT51P-3 Specifications

General

Brand	Lennox
Model	V0STAT51P-3
Category	Controller
Language	English