Lennox V0STAT51P-3 User Manual

78
Dry Mode Settings
Setup humidity sensing from the controller.
1. Tap the Humidity Sensor button to enter the auto dry mode settings screen.
2. Slide the button on the right of Auto Dry and choose whether to enable the Auto Dry function.
3. Slide the slider on the right of Dehumidier Contact and select whether to install the dehu-
midier in the indoor unit.
4. Slide the value below Target RH% to set the indoor target humidity. The highlighted value in
the middle is the current set parameter.
5. Slide the number below Cuto󰀨 to set the limit when the Cuto󰀨 dehumidication operation
temperature is lower than the set temperature. The highlighted value in the middle is the
currently set parameter.
Figure 102. Occupancy Sensor Function Settings

Lennox V0STAT51P-3 Specifications

General

Brand	Lennox
Model	V0STAT51P-3
Category	Controller
Language	English