8400 StateLine C | Operating instructions
Before commissioning
Check software version (firmware version)
26 L from Firmware V06.00 - DMS 1.1 EN - 11/2011
C00002/19
C00002/21
C00003
5.5 Check software version (firmware version)
Particularly with regard to the use of older controllers (e.g. if the customer is using one
from stock) it makes sense to check the software (firmware) version.
Reset error
Note: After the reset (acknowledgement) of the current error, further errors may be pending which must also be
reset.
• The current error is displayed in C00170.
Selection list (Lenze setting printed in bold) Info
0Off / ready
1 On / start Reset (acknowledge) current error
Delete logbook
Selection list (Lenze setting printed in bold) Info
0Off / ready
1 On / start Delete all entries in the logbook of the controller
Status of the last device command
Status of the device command executed last (C00002).
Note:
Before switching off the supply voltage after carrying out a device command, check whether the device command
has been carried out successfully via the status display!
The software version of the controller can be seen on
the nameplate in the "HW/SW" line and can be
determined by reading out code C00099.
Firmware version
C00099
06.00.00.00
To Next Page
Loading...
Need help?
General
