18
6.1.6. Light kit
6.1.7. Horn
6.1.8. Locking/ unlocking the wheelchair
The VR2 control system can be locked to prevent unauthorized use. The locking
method is via a sequence of key presses and joystick movements, as detailed
below:
To lock the wheelchair:
• While the control system is switched on, press and hold the on/off button.
• After 1 second the control will beep. Now release the on/off button.
• Move the joystick forwards until the control system beeps.
• Move the joystick in reverse until the control system beeps.
• Release the joystick, there will be a long beep.
• The wheelchair is now locked.
To unlock the wheelchair:
• Use the on/off button to switch the control system on. The speed indicator
will be rippling up and down.
• Move the joystick forwards until the control system beeps.
• Move the joystick in reverse until the control system beeps.
• Release the joystick, there will be a long beep.
• The wheelchair is now unlocked.
If you chose the optional light kit for
your chair, the keypad looks as
shown on the left.
To activate the lights, press the light-
button to switch on the two front and
two rear lights on your chair.
To indicate a left turn, press the left
indicator-button. To indicate to the
right, press the right indicator button.
If you have a breakdown or you
would like to call attention to youself,
you can activate all indicators at the
same time with the warning-lights-
button.
To Next Page
Loading...
Need help?
General