ENGLISH
16
Clock Setup
Clock Source
• You can select ‘O’, ‘NTP’, ‘Admin’.
• NTP : Clock is synchronized using Network Time Protocol. It's only enabled when network cable is connected.
• Admin : It's automatically set to Admin when clock is updated by commercial protocols like TVLink-HCEC.
• O : Clock is synchronized using any available clock source.
-
Input (Depending upon model)
» You can select 'Input' according to 'Clock Source'.
» Input is set to 'None', 'HCAP', 'Protocol', 'HTNG' automatically when Clock Source is 'Admin'.
Password Change
• To ensure more security, Password can be changed by installers’ own design.
1 Change password by using virtual keyboard.
2 Input the password again for conrmation.
Lock Mode
• If ‘Lock Mode’ is ‘Yes’, the following features will be unavailable.
USB
• If it is set to ‘Enable’, USB devices do not work in relative features. (Exclude S/W update)
Factory Reset
• If it is set to ‘Enable’, User Menu General Reset to Initial Settings is disabled.
Crestron
(Depending upon model)
• This function enables synchronization with applications provided by Crestron.
• Server: This menu sets the server’s IP address for the network connection with the server. (equipment provided
by Crestron)
• Port (1024~65535): This menu sets the port for the network connection with the server. The default port
number is 41794.
• IP ID (3-254): This menu sets a unique ID for synchronizing with the application.
To Next Page
Loading...
Need help?
General
