ENGLISH
9
Power On Default
• Set to On (Work) or O (Do Not Work).
• When ‘Power On Default’ is set to O, it is not applied to the subordinate Input, A/V Setting, Aspect Ratio
menu.
• When Power On Default is set to On, it can set by entering the subordinate menu.
Input
• Set whether it is turned on by the set input source or by the last stored input source.
A/V Setting
• If ‘A/V Setting’ is changed from ‘O’ to ‘On’, A/V parameters that are set before entering ‘Installation Menu’ are
applied whenever turn on power.
Aspect Ratio
• The aspect ratio determines the default aspect ratio that the set returns to on power up.
Aux Source Setting
• Set to On (Work) or O (Do Not Work).
• The Auxiliary (Input) Source Setting feature will enable or disable for each external input.
• User cannot disable the current input’s ‘Aux Source Setting’.
Power Management
• The Power Management feature will turn o the Signage if no input control command is received from either
the Local or IR Key within selected hours.
-
Activity on either of these inputs shall reset the ‘Power Management’ timer and prevent interruption of
Signage viewing.
-
This entry can be set to a value which is corresponding to the desired hours (1 hour to 7 hours).
-
Default value is ‘Off (disabled)’.
Factory Reset
• Change all settings to their default values.
To Next Page
Loading...
Need help?
General
