26
USING THE PROJECTOR
Menu Description
Full
Wide
When projector receives the
wide screen signal, it will
let you adjust the picture
horizontally or vertically,
in a linear proportion,to ll
the entire screen fully. 4:3
and 14:9 video is supported
in full screen without any
video distortion through
DTV input.
y
In Analogue/DTV/AV
mode, Full Wide is
available.
4:3 Resizes images to the
previous standard 4:3.
14:9 You can view a picture
format of 14:9 or a general
projector programme in the
14:9 mode. The 14:9 screen
is viewed in the same way
as in 4:3, but is moved up
or down.
Zoom Resizes the image to t the
screen width. The top and
bottom parts of the image
may be cut off.
Press the or button to
zoom in or out of the image.
Press the or button to
move the image.
Cinema
Zoom 1
Formats an image to the
cinemascope ratio, 2.35:1. It
ranges from 1 to 16.
Press the
or
button to
zoom in or out of the image.
Press the
or
button to
move the image.
y
If you enlarge or reduce
an image, the image may
be distorted.
Additional Options
Adjusting Aspect Ratio
y
Select SETTINGS → PICTURE →
Aspect Ratio to change the aspect
ratio.
NOTE
y
Available picture size may differ
depending on the input signal.
y
You can also use the Q.MENU button.
Menu Description
16:9 Resizes images to t the
screen width.
Full Changes to the full screen
regardless of the aspect
ratio.
Just
Scan
Displays video images in
the original size without
removing parts of the edge
of the image.
y
If you select Just Scan,
you may see image
noises at the edge or
edges of the screen.
Original When your projector
receives a wide screen
signal it will automatically
change to the picture format
broadcasted.
To Next Page
Loading...
Need help?
General
