27
USING THE PROJECTOR
Using the Keystone
Function
To prevent the screen image from
becoming trapezoidal, Keystone adjusts
the top and bottom width of the image
if the projector is not set up at a right
angle to the screen.
Because the Keystone function may
cause inferior screen image quality, use
this function only when it is not possible
to set up the projector at an optimal
angle.
Close
L R
1
Select SETTINGS → OPTION 2 →
Keystone to adjust the picture.
y
Keystone can be adjusted from -40 to
40.
2
Press the OK button when done.
Changing input device
To select an external input
Selects external input.
y
Press the INPUT button on the
remote control to display the input
selection screen.
- Connected inputs are displayed
first. However, Antenna / AV /
Component / SCREEN SHARE
input is always activated.
y
Select an input signal using the
remote control's INPUT button to
connect the projector to the desired
input. You can use the , , , or
button to switch between all the input
modes.
Antenna AV Component
SCREEN SHARE
USB RGB
ExitInput Label
To Next Page
Loading...
Need help?
General
