50
3D FUNCTION
y
You may see left and right images
overlapped during projector
initialization after it is powered on. It
may take some time for optimization.
y
It may take some time for the 3D
image to look normal after you turn
your eyes away from the screen and
look back at the 3D image.
y
It may flicker slightly while watching
3D images under a 3 wavelength
lamp fluorescent light (50 Hz - 60
Hz) or near windows. If so, it is
recommended to block the sun light
with a curtain and to dim the lights.
y
The 3D glasses must be DLP-LINK
(DLP Ready) type.
y
You may not be able to watch 3D
properly if there is an obstacle
between the projector and 3D
glasses.
y
Install the 3D projector as far as
possible from other devices.
y
If a future 3D broadcasting format
that is not supported by this projector
becomes the standard, an additional
device such as a set-top box may be
required.
Please check the following when
using 3D glasses.
y
Do not use 3D glasses as ordinary
glasses, sunglasses or protective
goggles.
- If you do so, this may cause injury.
y
Do not store 3D glasses in very hot
or very cold conditions. If you do, this
may cause them to become distorted.
Do not use distorted glasses.
y
Do not drop 3D glasses or allow
them to come into contact with other
objects.
- This may cause product malfunction.
y
The lenses of 3D glasses are easily
scratched. Use a soft clean cloth
when cleaning them.
y
Foreign particles on the cloth may
cause scratches.
y
Do not scratch the surface of the 3D
glasses' lenses with sharp objects
or wipe them with chemicals. If the
lenses get scratched, images may not
look normal when viewing 3D.
To Next Page
Loading...
Need help?
General
