13
ENGLISH
INSTALLATION INSTRUCTIONS
Unpacking and rem oving shipping bolts
When removing the washer from the carton base, be
sure to remove the foam drum support in the middle of
the carton base.
If you must lay the washer down to remove the base
packaging materials, always lay it carefully on its side.
Do NOT lay the washer on its front or back.
1
Remove the bottom two shipping bolts with the
wrench (included) to fully loosen all four shipping
bolts by turning them counterclockwise and then
pulling them out.
Shipping
bolt
Retainer
2
Locate the four hole caps included in the accessory
pack and install them in the shipping bolt holes.
Cap
NOTE
!
Save the bolt assemblies for future use. To prevent
damage to internal components, DO NOT transport
the washer without reinstalling the shipping bolts.
!
Failure to remove shipping bolts and retainers
may cause severe vibration and noise, which can
lead to permanent damage to the washer. The
cord is secured to the back of the washer with
a shipping bolt to help prevent operation with
shipping bolts in place.
To Next Page
Loading...
Need help?
General
