44
SPECIFICATION
Problem Possible Causes Solutions
Wrinkling
!
Did you remove the load immediately after
it finished?
!
Did you overload the tub?
!
Did you reverse the hot and cold water
inlets?
!
Remove the load immediately after it
finishes.
!
Do not overload the tub.
!
H ot water rinse can cause garments to
wrinkle. Check the inlet hose connections.
Power is not turned on
!
Is the power cord plugged in properly?
!
H as a house fuse blown, a circuit breaker
tripped, or a power outage occurred?
!
M ake sure that the plug is secured in a
grounded 3-prong, 120 V (60 H z) outlet.
!
Reset the circuit breaker or replace the
fuse. Do not increase the fuse capacity. If
the problem is a circuit overload, have it
corrected by a qualified electrician.
The door does not open
when the cycle pauses or
finishes
!
Is the temperature in the tub too high?
!
Is the water level in washer high?
!
The washing machine has a safety lock
built into the door to prevent burning.
Leave the door closed and wait until the
door lock icon disappears from the display.
!
Allow the washer to complete the
programmed cycle, or Press the Spin
button.
The wash cycle time is
longer than usual
!
Is the washing machine overloaded? Are
other options added to the wash cycle?
!
This is normal. The washing machine
automatically adjusts the cycle time for
the amount of laundry, water pressure,
water temperature, and other operating
conditions.
It is musty or moldy in the
tub
!
H as the incorrect detergent been used?
!
Did you clean the tub periodically?
!
See page 37, clean the inside and outside
of the washing machine periodically.
SPECIFICATIONS
M odel WM 3570 H * A
Description Front Loading Washer
E lectrical requirements 120 V AC @ 60 H z
Dimensions 68.6 cm (W) X 75.6 cm (D) X 98.3 cm (H ), 129.5 cm (D with door open)
27" (W) X 29
3
/
4
" (D) X 38
11
/
16
" (H ), 51" (D with door open)
Net weight 92kg(20 2.8lbs)
M ax. spin speed 130 0 RPM
M ax. water pressure 14.5 – 142 PSI (10 0 – 980 kpa)
To Next Page
Loading...
Need help?
General
