UCX series – User's Manual 105
Overview
Advanced View
Instructions for the Terminal Application Usage
Terminal Application
switcher using a terminal application. You need to
install one of them to your control device, for example
Putty or CLI. #terminal
Establishing Connection
Follow the steps for establishing connection to the
switcher:
Step 1.
Step 2. Open the terminal application (e.g. Putty).
Step 3. Add the IP address of the device (default:
DHCP) and the port number (6107).
Step 4. Select the Raw connection type, and open the
connection.
Once the terminal window is opened, you can enter
following sections.
LW3 protocol command communication in a terminal window
Instructions for the Websocket (WS) or Secured Websocket (WSS) Usage
DIFFERENCE:
v1.2.0.
with section.
▪ <ip>
▪ <ip>
WebSocket Client Application
Establishing Connection
Follow the steps for establishing connection to
the switcher:
Step 1.
Ethernet.
Step 2. Open the websocket client (e.g. Simple
websocket Client).
Step 3. Add the IP address of the device (default:
DHCP): <ip><ip>
Step 4.
Step 5. Once connected, enter a message
and press the Send button.
protocol commands which are listed in
the following sections
Step 6.
end the session.
To Next Page
Loading...
Need help?
General
