12
Battery Replacement for the Remote Control
The remote control requires a CR2025, 3V Lithium battery.
1. Slide and hold the battery release tab in the direction of
the arrow.
2. Pull out the battery compartment and remove the
old battery.
3. Replace with a new battery.
4. Insert the battery compartment back into the
remote control.
Removing the plastic strip from the Remote Control
Remove the plastic strip from the batteries if the batteries are
being used for the rst time. It is located at the bottom rear
side of the remote controls.
Handling the Battery
• Improper or incorrect use of batteries may cause corrosion or battery leakage,
which could cause re, personal injury or damage to property.
• Install the battery correctly by following the polarity (+ and –) indications in the
battery compartment.
• When the battery is exhausted, the remote control will not function.
• Only use the battery type indicated in this manual.
• Do not dispose of the used battery as domestic waste. Dispose of it in
accordance with the local regulations.
• Small button cell batteries such as the one used in the remote control are
easily swallowed by young children and this is dangerous. Keep loose button
cells away from young children and make sure that the battery holder tray is
secure in the remote control. Seek medical advice if you believe a cell has been
swallowed.
L10SPDV13_IB_161013_will.indd 12 13/10/2016 10:09 AM
To Next Page
Loading...
Need help?
General
