Marshall Amplification JVM410H User Manual

ENGLISH
loop is located aer the preamp in the
signal chain, right before the reverb and
serial loop circuits. Pressing the FX LOOP
switch engages this FX loop.
10. FOOTSWITCH / MIDI PROGRAM
This switch has a dual funcon:
Pressing it once we enter the
FOOTSWITCH PROGRAM mode. It is
indicated by a connuous red light.
Pressing it twice we enter the MIDI
PROGRAM mode. It is indicated by a
blinking red light.
FOOTSWITCH PROGRAM AND USE
The JVM4 Series features Stompware®
footswitching. The footswitch connecon
to the amplier requires a standard mono
1/4” jack to jack cable. Any guitar lead will
work and praccally there should be no
limit in its length.
When the front panel FOOTSWITCH
/ MIDI PROGRAM switch is ‘o’, the
footswitch operates in normal mode and
executes the commands the moment a
buon is pressed down.
If you enter the FOOTSWITCH PROGRAM
mode (LED red) you will be able to program
the footcontroller, but nevertheless the
footcontroller and the amplier will remain
fully operaonal with the only dierence
being that the commands will be executed
when releasing a buon, as opposed to the
normal mode.
The 6-way Stompware® footswitch has
2 modes of operaon: Preset Store and
Switch Store.
PRESET STORE MODE
Any of the footswitch buons can be
congured to store the current amplier
status. The current channel, master, FX and
reverb status will be stored and recalled
when the respecve footswitch buon is
pressed.
To store the current status:
a) Set the amplier to FOOTSWITCH
PROGRAM mode (red light ON).
b) Press and hold the desired switch for
about 3 seconds.
c) The footswitch FX LED will icker a
couple of mes indicang that the preset
has been stored.
SWITCH STORE MODE
Any of the footswitch buons can be
congured to control the front panel
switches, with the amplier reacng in
exactly the same way as when you operate
the switches on the front panel.
All the front panel switches can be mapped
to any of the buons without limitaon.
The only excepon is the FOOTSWITCH
/ MIDI PROGRAM key, which cannot be
assigned to the footswitch.
To assign any of the front panel buons
(except FOOTSWITCH / MIDI PROGRAM)
to any of the footswitch buons:
a) Set the amplier to FOOTSWITCH
PROGRAM mode (red light ON).
b) Press and hold the desired buon.
c) While holding the buon down, in less
than 3 seconds, press the front panel
buon that you want to map.
d) The footswitch FX LED will icker a
couple of mes indicang that the switch
has been mapped.
Book-00086-01 - 04/17 (JVM4_Manual86_FINAL_19.04.17).indd 11 28/04/2017 11:14

Marshall Amplification JVM410H Specifications

General

Brand	Marshall Amplification
Model	JVM410H
Category	Amplifier
Language	English