Marshall Amplification JVM410H User Manual

WARNING! IMPORTANT SAFETY INSTRUCTIONS
ENGLISH
WARNING:
Before going any further, make sure that
your amplier is compable with your
mains electricity supply. If you have any
doubt, please seek help from a qualied
technician – your Marshall dealer can help
you in this respect.
MAINS INPUT & FUSE:
The specic mains input voltage rang
that your amplier has been manufactured
for is indicated on the rear panel of the
amplier. Your amplier is provided with
a detachable mains (power) lead, which
should be connected to the MAINS INPUT
socket on the rear panel of the amplier
(Rear Panel Function #13). The correct
value and type of mains fuse is specied
on the rear panel of the amplier. NEVER
aempt to bypass the fuse or t one of the
incorrect value or type.
TRANSPORTING YOUR EQUIPMENT:
Please ensure that your amplier is
switched o, unplugged from the mains
electricity supply and all removable
cables have been disconnected from your
equipment before aempng to move it.
IMPORTANT SET UP INFORMATION:
1. When using JVM410H head, or
JVM410C combo with an extension speaker
cabinet(s), make sure that the speaker
cabinet(s) is connected to the correct
impedance loudspeaker jack socket(s) on
the rear panel of the amplier. See the
LOUDSPEAKERS guide in this manual for
specic informaon regarding impedance
matching (Rear Panel Function #19).
WARNING Failure to do the above may
damage your amplier. When connecng
a speaker cabinet make sure that you
use a proper speaker cable. Never use a
screened (shielded) guitar cable for this
purpose.
2. Ensure that the POWER switch (Front
Panel Function #12) is set to the OFF
posion.
3. Connect the supplied mains (power)
lead into the MAINS INPUT (Rear Panel
Function #13) rst and then into the mains
electricity supply.
4. Ensure that the MASTER 1 and MASTER
2 controls on the front panel are set to
zero (Front Panel Function #7).
5. Plug your guitar into the INPUT jack
socket on the front panel (Front Panel
Function #1).
6. Ensure that the STANDBY switch (Front
Panel Function #11) is in the OFF posion.
7. Turn the front panel POWER switch
to the ON (I) posion and wait for a few
minutes before going to point 8.
8. Engage the amplier by switching
STANDBY to the ON posion.
9. Turn the volumes up to your preferred
level and your amplier is ready to play.
PLEASE READ THIS MANUAL CAREFULLY BEFORE PLUGGING IN.
FOLLOW ALL INSTRUCTIONS AND HEED ALL WARNINGS.
KEEP THESE INSTRUCTIONS.
Book-00086-01 - 04/17 (JVM4_Manual86_FINAL_19.04.17).indd 2 28/04/2017 11:14

Marshall Amplification JVM410H Specifications

General

Brand	Marshall Amplification
Model	JVM410H
Category	Amplifier
Language	English