MasterCraft X25 User Manual

Also note that the underwater lights should never be operated unless the boat is
in the water. Even though these are L.E.D. lights, they generate some heat and require
the cooling eect of the water to avoid premature burn-out of the bulb.
Wash Down Switch
(Optional installation for X Series)
A water tank option within available models can provide a
fresh-water wash of the boat interior. The tank will be eight (8)
or twenty-five (25) gallons capacity, depending on the boat
model. The two-position switch is pressed up for ON and down
for OFF.
Comfort and Convenience
MasterCraft oers significant standard and optional items to make the boating
experience more enjoyable. Some of these items come with their own instructions and
information from the original manufacturer. In those instances, such as with the stereo
equipment, the manual is included with the boat. In other instances, some general infor-
mation is provided in this section.
If, at any time, you are uncertain about the use or care of anything on the boat, never
hesitate to contact your authorized MasterCraft dealer for additional information and
guidance.
Anchor
Some models are equipped with anchors, and there will be a designated storage
area or stowage location on the boat. Check with your dealer if you are uncertain about
this area as it is important to keep the anchor stowed when it is not in use.
Improperly stored anchors and/or anchor
line that has been improperly re-wound,
may create a hazardous situation. People
on-board can trip on improperly stored
materials, which can result in injury. Im-
properly stored materials can also move too freely during boat opera-
tion and make contact with individuals, again causing injury. Properly
store all anchor and lines whether the boat is in operation or not, un-
less the anchor and line are in use.
The anchor has been provided to assist
boaters in remaining in a chosen loca-
tion. Note that use of the anchor system
will not guarantee a properly anchored
boat or that the boat will remain in a sta-
tionary position. Environmental, bottom conditions, current and tidal
conditions must be taken into consideration when anchoring the boat.
Only properly trained operators should set the anchor for this system.
Establishing a secure anchorage requires practice. Damage to your
boat may result due to improper anchoring techniques.
2013 MasterCraft Owners Manual • Electronic Instrumentation • Page 3-22

MasterCraft X25 Specifications

General

Brand	MasterCraft
Model	X25
Category	Boat
Language	English