2013 MasterCraft Owners Manual • Electronic Instrumentation • Page 3-7
This button only aects the engine. The electrical
system will continue to operate as long as the key
is turned. If the key is left turned on after the outing,
it will eventually run down the battery(ies) and the
engine and all systems will not start as a result.
•Attheconclusionoftheouting,turnthekeyo
and remove from the key slot. Doing so will ensure
that you have turned OFF the electrical system, and
prevent others from starting or running the boat.
Navigation/Anchor Lights Switch
(All Models)
A three-position switch serves to activate exterior
lighting. Turning the switch to the right position will
activate bow and stern lights, the middle position is
OFF, and the left position is for stern-only lighting.
Performance Controls
This section discusses the performance controls. On some
models, information is provided via traditional gauges and
switches. On many models, however, this information (as
well as some convenience and support data described else-
where in this owner’s manual) is given through a video display
gauge. Several dierent video display gauges are mounted in
the boats, depending on the model. Descriptions of the func-
tionality of those gauges follows in the next section. Please
note that some refinement of these gauges was in progress at
press time. Therefore, the gauge in your boat may have some
minor variances to what is described in this manual. Master-
Craf strongly encourages you to review ALL instrumentation
with your authorized MasterCraf dealer prior to operating the
boat for the first time, and at any time during ownership of the
boat if you are uncertain as to proper and applicable function-
ality.
Left: X-Star start-stop;
Right: All other XSeries.
To Next Page
Loading...
Need help?
General
