68
9.18 HEART RATE HANDLEBAR REPLACEMENT
1) Turn off power to the treadmill and remove the power cord.
2) Remove the console as outlined in Section 9.12.
3) Remove the console frame as outlined in Section 9.15.
4) Remove the 3 screws on each side holding the handlebar frame to the console mast (Figure A).
5) Lift the handlebar frame up and away from the console mast (Figure B). NOTE: The console cable wiring will need to be removed from the
handlebar frame on the user's right side as it is removed.
6) Remove the screw on each side holding the heart rate handlebar to the handlebar frame (Figure C).
7) Pull the two sides of the handlebar frame away from each other and remove the heart rate handlebar from the handlebar frame.
8) Reverse Steps 1-7 to install a new heart rate handlebar.
9) Test the treadmill for function as outlined in Section 9.21.
FIGURE A FIGURE B
FIGURE C
CHAPTER 9: PART REPLACEMENT GUIDE
To Next Page
Loading...
Need help?
General
