34 16022904 Rev. 0 ©2004 Maytag Appliances Company
Troubleshooting Procedures
WARNING
To avoid risk of electrical shock, personal injury or death, disconnect power to unit before servicing, unless testing
requires power.
Stack Dryer Diagnostic Program
Dryer
Diagnostic
Program
Enter Operator
Mode by unlocking
the service switch
If a diagnostic
code is displayed
refer to
corresponding
section of trouble
shooting guide.
To enter
diagnostic mode
or clear diagnostic
codes press a
delicates keypad
for at least 1
second. customer
cycles will be
terminated
If any segments of display
are not flashing. Replace
the control board.
Dryers should be
near room
temperature,
plugged in, and
doors closed.
To initiates a
service cycle push
the permanent
press keypad for
the dryer(s) to be
started-- upper or
lower.
Is dryer drum
turning?
Is heater on? (Allow
ample time for gas
flames to ignite)
Dryer check ok.
Refer to dryer
drum will not turn
section.
Refer to no heat
section.
If desired, push
the respective
delicates keypad
to cancel the
service cycle.
Exit operator mode
by locking the
service door.
Yes
No No
Yes
To Next Page
Loading...
Need help?
General
