54
Getting started
Driving
Intermittent wiping
왘 Set the combination switch to
position I.
Single wipe
왘 Press combination switch briefly in
direction of arrow 1.
The windshield wipers wipe one time
without washer fluid.
Wiping with windshield washer fluid
왘 Push combination switch in direction of
arrow 1 past the resistance point.
The windshield wipers operate with
washer fluid.
For information on filling up the washer
reservoir, see “Windshield/rear window
washer system and headlamp cleaning
system” (
컄 page 245).
Rear window wiper/washer
The rear window wiper/washer switch is
located on the upper part of the center
console.
1 Interval wiping on/off
2 Indicator lamp
3 Simultaneous operation of wiper and
washer
i
Intermittent wiping is interrupted when
the vehicle is at a standstill and a front
door is opened.
!
If anything blocks the windshield wip-
ers (leaves, snow, etc.), switch them off
immediately.
앫 For safety reasons, withdraw
SmartKey from starter switch be-
fore attempting to remove any
blockage.
앫 Remove blockage.
앫 Turn the windshield wipers on
again.
If windshield wipers fail to function at
all in combination switch position I,
앫 set the combination switch to the
next highest wiper speed.
앫 have the windshield wipers
checked at the nearest authorized
Mercedes-Benz Light Truck Center.
To Next Page
Loading...
Need help?
General
