Bulkhead with sliding door
Details & Technology
The bulkhead with sliding door is situated in the B-pillar area. The sliding door is fitted with a
door lock and locking cylinder. From the driver's side, the sliding door is opened by means of
the vehicle key, and from the load compartment side by means of a lever on the door lock.
The aluminum sliding door is 577 mm wide, 1775 mm high and 17 mm thick
[approx. 21
5/8
x 71 ¼ x 11/16 inch]. The open sliding door is held in place at the end of its
travel by a retainer. On the right-hand side, in the entrance area of the sliding load-
compartment door, the bulkhead is fitted with a grab handle (Code T77).
The bulkhead can be ordered with jump seat S20 (see note below)
Benefits & Arguments
Serves to secure load, in conjunction with lashing eyelets
Provides direct access to the load compartment
Makes it possible to communicate verbally between the cab and the load compartment
Keeps dirt, dust and odors produced by the load out of the driver's compartment
Front cab can be heated up quickly
Fitting the bulkhead - in conjunction with the tie-down points - makes it possible to secure
the load in accordance with regulations. It also makes it possible to stack the load in such a
way that it can be restrained by direct means.
The sliding door provides direct access to the load compartment and makes it possible to
communicate verbally between the cab and the load compartment. When the sliding door is
closed, it is not possible to see the cargo.
Note:
Part of:
X02 Partition w/ Sliding Door & Passenger Jump
X03 Partition w/ Sliding Door without Passenger Jump Seat Package
Seat Package
©2015 Mercedes-Benz USA, LLC / Daimler Vans USA, LLC
To Next Page
Loading...
Need help?
General
