Tail Lamp Deleted
Details & Technology
The vehicle is supplied without lights or turn signal at the rear of the vehicle but with the
relevant connector and wiring.
Body builders can fit aftermarket lamps:
License plate light: 1.0A
Backup light: 2.4A
Turn signal: 1.75A -1.96A (max 2.1Amp)
Fog light: N/A (tape back)
Tail light: 1.0A
When using LED’s, a resistor must be used to compensate for the lower AMP draw. Turn
Signal LED’s AMP draw is recommended to be between 1.75A – 1.96A (max 2.1Amp)
otherwise rapid flashing will occur.
Please consult the Body Builder Information Book for further information.
Benefits
Pre-installation for alternative rear lights
Allows body manufacturers to fit alternative lights and direction indicators at the rear of the
vehicle.
©2015 Mercedes-Benz USA, LLC / Daimler Vans USA, LLC
To Next Page
Loading...
Need help?
General
