Special Tools
Power Steering Module Primer Kit 91‑895040K01
Bleeds power steering system without running engine.
Advanced Sound Control
Advanced sound control (ASC) is an exclusive feature on select horsepower Verado V8 engines.
NOTE: This feature is not available on SeaPro models.
•
ASC allows the vessel operator to toggle between two modes of operation: stealth or sport mode.
• The mode of operation can be selected with an accessory dash switch, VesselView, or SmartCraft gauge; off = stealth
mode, on = sport mode.
• When stealth mode is active, the engine noise levels are low (the typical smooth sound of Verado FourStroke power).
• When sport mode is active, the engine noise levels are higher (a definitive audible indicator of the engine's power).
NOTE: Stealth or sport modes does not affect the engine horsepower or the running characteristics of the engine.
When the engine is started, ASC will remain in the selected mode at the time when the engine was turned off.
Troubleshooting
If the advanced sound control modes do not appear to be changing, first inspect the 5‑amp fuse in the fuse block. If the fuse
has opened, inspect the wiring and connections for the cause. If the fuse checks good, connect CDS G3 and navigate to the
diagnostics screen. Perform the diagnostic test, and either listen for the actuator to respond while the engine is off, or listen for
a change in the exhaust noise while the engine is running and in the water. If the actuator does not appear to be responding,
use the following wiring diagram to check for power at the connector and continuity on the wires back to the PCM. If no issues
are discovered, replace the advanced sound control actuator and retest.
Accessories
Page 5C-2 © 2018 Mercury Marine 90-8M0146617 eng JULY 2018
To Next Page
Loading...
Need help?
General
