Miele G 7200 SCi User Manual

Before using for the first time
25
Dishwasher salt
In order to achieve good cleaning res-
ults, the dishwasher needs to operate
with soft water. Hard water results in
the build-up of calcium deposits on
crockery and on the wash cabinet walls.
Mains water with a water hardness level
higher than 0.9mmol/l (5°dH – German
scale) must be softened. This occurs
automatically in the integrated water
softener. The water softener is suitable
for a water hardness level of up to
12.6mmol/l (70°dH – German scale).
In order to maintain the functions of
the water softener, it must be reactiv-
ated regularly. Reactivation occurs
automatically every ninth programme
sequence. At the start of the next pro-
gramme, an additional 4.4l of water is
required for this process. Energy con-
sumption increases by 0.015kWh and
the programme is extended by approx.
3minutes.
The above only applies to the ECO
programme at a water hardness of
2.5mmol/l (14°dH – German scale).
For other programmes and water
hardness levels, the frequency of re-
activation will differ.
In order to be reactivated, the water
softener requires dishwasher salt.
Depending on the water hardness level
(<3.8mmol/l, or <21°dH – German
scale), dishwasher salt is not required if
combination detergents are being used
(see “Detergent – Powder detergent and
detergent tabs”).
If the water in your area is very soft
and constantly lower than 0.9mmol/l
(5°dH – German scale), you do not
need to add dishwasher salt. The salt
refill indicator will automatically switch
off after the water hardness has been
set accordingly (see “Settings – Water
hardness”).
 Damage to the water softener
from detergent.
Detergent will damage the water
softener.
Do not fill the salt reservoir with
powder or liquid detergent.
 Damage caused by using unsuit-
able salts.
Some types of salt may contain in-
soluble components which can
cause the water softener to malfunc-
tion.
Only use special coarse-grained
dishwasher salt or other pure kitchen
salt for reactivation.
If you only ever use combination de-
tergent products in your dishwasher,
you can turn off both refill reminders if
you wish (see “Settings – Refill re-
minders”).
Please make sure that if you stop us-
ing combination detergent products,
you refill the dishwasher salt and
rinse aid. Switch the refill reminders
back on if required.

Miele G 7200 SCi Specifications

General

Door color	Not applicable
Water fill	Cold, Hot
Cord length	1.7 m
Control type	Buttons
Product size	Full size (60 cm)
Inlet hose length	1.5 m
Custom panel-ready	Yes
Appliance placement	Semi built-in
Control panel color	Black
Cutlery compartment type	Drawer
Cycle time	230 min
Noise level	43 dB
Drying system	Condensation
AquaStop function	-
Delay start (max)	24 h
Dishwashing programs	Auto, Eco, Express, Glass/delicate, Intensive 75°C, Quick, Silent
Number of place settings	14 place settings
Number of washing programs	8
Maximum hot water supply temperature	60 °C
Current	10 A
Connected load	2000 W
AC input voltage	230 V
AC input frequency	50 Hz
Energy efficiency scale	A to G
Water consumption per cycle	8.4 L

Weight and Dimensions

Depth	570 mm
Width	598 mm
Height	805 mm
Weight	47200 g
Depth with door open	1165 mm
Custom panel weight (max)	10000 g
Custom panel weight (min)	3000 g
Installation compartment width	600 mm
Installation compartment height (max)	870 mm