Problem solving guide
77
Many malfunctions and faults that can occur in daily operation can be easily
remedied. Time and money will be saved because a service call will not be
needed.
The following guide may help you to find the reason for a malfunction or a fault,
and to correct it.
This section only lists faults that you can remedy yourself. All other faults are
shown in Fault FXX.
Technical problems
Problem Cause and remedy
The display remains
dark and the Start in-
dicator light is not
flashing after the dish-
washer has been
switched on with the
button.
The dishwasher is not plugged in.
Insert the plug and switch on at the socket.
The mains fuse has tripped.
Reset the trip switch in the fuse box or replace the
fuse in the plug (see data plate for minimum fuse
rating).
If the mains fuse trips again, contact the Miele
Customer Service Department.
The button does not
respond immediately or
only responds once it
has been pressed sev-
eral times.
Energy management: the door was opened or closed
shortly before the button was pressed. As a result,
the dishwasher was already switched on. The elec-
tronic module requires a few seconds to be ready for
operation.
Wait a few seconds after opening or closing the
door.
Then press the button.
The dishwasher stops
during a programme.
The mains fuse has tripped.
Reset the trip switch in the fuse box or replace the
fuse in the plug (see data plate for minimum fuse
rating).
If the mains fuse trips again, contact Miele Ser-
vice.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
