Miele G 7200 SCi User Manual

Installation
*INSTALLATION*
93
 Risk of damage from leaking wa-
ter.
The connection point is subject to
mains water pressure. Water leaking
from it can cause damage.
You should therefore open the stop-
cock slowly and check for leaks.
Correct the position of the seal and
screw thread if appropriate.
Regulation in Germany
For the protection of drinking water, the
non-return valve supplied with the dish-
washer must be installed between the
stopcock and the water inlet hose.
 Screw the non-return valve onto the
stopcock.
 Screw the water inlet hose onto the
thread of the non-return valve.
 Risk of damage due to excessive
pressure.
A brief increase in the water pressure
can damage components of the
dishwasher.
This dishwasher must only be oper-
ated when it is connected to a fully
vented plumbing system.
 Risk of electric shock from mains
voltage.
There are electrical components in
the water inlet hose.
The inlet hose must not be shortened
or damaged in any way (see illustra-
tion).

Miele G 7200 SCi Specifications

General

Door color	Not applicable
Water fill	Cold, Hot
Cord length	1.7 m
Control type	Buttons
Product size	Full size (60 cm)
Inlet hose length	1.5 m
Custom panel-ready	Yes
Appliance placement	Semi built-in
Control panel color	Black
Cutlery compartment type	Drawer
Cycle time	230 min
Noise level	43 dB
Drying system	Condensation
AquaStop function	-
Delay start (max)	24 h
Dishwashing programs	Auto, Eco, Express, Glass/delicate, Intensive 75°C, Quick, Silent
Number of place settings	14 place settings
Number of washing programs	8
Maximum hot water supply temperature	60 °C
Current	10 A
Connected load	2000 W
AC input voltage	230 V
AC input frequency	50 Hz
Energy efficiency scale	A to G
Water consumption per cycle	8.4 L

Weight and Dimensions

Depth	570 mm
Width	598 mm
Height	805 mm
Weight	47200 g
Depth with door open	1165 mm
Custom panel weight (max)	10000 g
Custom panel weight (min)	3000 g
Installation compartment width	600 mm
Installation compartment height (max)	870 mm