Miele G 7200 SCi User Manual

Before using for the first time
27
Refilling the salt
 When Refill salt appears in the dis-
play, wait until the end of the pro-
gramme and then refill the salt reser-
voir.
 Confirm with OK.
The salt refill indicator will go out.
 Risk of corrosion due to saline
solution.
Saline solution that runs out can
cause corrosion in the wash cabinet
and to the load items.
Each time you remove the salt reser-
voir cap, you must run the
65°CQuickPowerWash pro-
gramme with the Express pro-
gramme option selected without any
load items in the dishwasher. This
will dissolve and remove any traces
of salt from the wash cabinet.
After the salt reservoir has been filled,
the salt refill indicator may still appear in
the display if the salt concentration has
not yet reached the correct level. In this
case, confirm the message again with
OK.
The salt refill indicator will be switched
off if you have programmed the dish-
washer for a water hardness below
0.9mmol/l (5°dH – German scale).

Miele G 7200 SCi Specifications

General

Door color	Not applicable
Water fill	Cold, Hot
Cord length	1.7 m
Control type	Buttons
Product size	Full size (60 cm)
Inlet hose length	1.5 m
Custom panel-ready	Yes
Appliance placement	Semi built-in
Control panel color	Black
Cutlery compartment type	Drawer
Cycle time	230 min
Noise level	43 dB
Drying system	Condensation
AquaStop function	-
Delay start (max)	24 h
Dishwashing programs	Auto, Eco, Express, Glass/delicate, Intensive 75°C, Quick, Silent
Number of place settings	14 place settings
Number of washing programs	8
Maximum hot water supply temperature	60 °C
Current	10 A
Connected load	2000 W
AC input voltage	230 V
AC input frequency	50 Hz
Energy efficiency scale	A to G
Water consumption per cycle	8.4 L

Weight and Dimensions

Depth	570 mm
Width	598 mm
Height	805 mm
Weight	47200 g
Depth with door open	1165 mm
Custom panel weight (max)	10000 g
Custom panel weight (min)	3000 g
Installation compartment width	600 mm
Installation compartment height (max)	870 mm