Miele G 7200 SCi User Manual

Cleaning and care
74
Cleaning the water inlet filter
A filter is incorporated in the screw
thread to protect the water inlet valve. If
the filter is soiled, insufficient water
flows into the wash cabinet.
 Risk of electric shock from mains
voltage.
The plastic housing of the water con-
nection contains an electrical valve.
The housing must not be dipped in
water.
 Disconnect the dishwasher from the
mains.
To do this, turn off the dishwasher,
switch off at the socket and remove
the plug.
 Close the stopcock.
 Unscrew the water inlet valve.
 Remove the seal from the screw
thread.
 Using pointed pliers, take hold of the
plastic filter slat and remove the filter.
 Rinse the filter under running water.
 Reassemble in reverse order.
Screw the screw thread securely
back onto the stopcock. Slowly open
the stopcock. If water drips out,
tighten the screw thread.
Never forget to put the filter back in
place after cleaning.

Miele G 7200 SCi Specifications

General

Door color	Not applicable
Water fill	Cold, Hot
Cord length	1.7 m
Control type	Buttons
Product size	Full size (60 cm)
Inlet hose length	1.5 m
Custom panel-ready	Yes
Appliance placement	Semi built-in
Control panel color	Black
Cutlery compartment type	Drawer
Cycle time	230 min
Noise level	43 dB
Drying system	Condensation
AquaStop function	-
Delay start (max)	24 h
Dishwashing programs	Auto, Eco, Express, Glass/delicate, Intensive 75°C, Quick, Silent
Number of place settings	14 place settings
Number of washing programs	8
Maximum hot water supply temperature	60 °C
Current	10 A
Connected load	2000 W
AC input voltage	230 V
AC input frequency	50 Hz
Energy efficiency scale	A to G
Water consumption per cycle	8.4 L

Weight and Dimensions

Depth	570 mm
Width	598 mm
Height	805 mm
Weight	47200 g
Depth with door open	1165 mm
Custom panel weight (max)	10000 g
Custom panel weight (min)	3000 g
Installation compartment width	600 mm
Installation compartment height (max)	870 mm